|
|
Entries for December 2010
admin posted on December 08, 2010 00:00
Reinforces its position in specialty surfactants.
[Read the rest of this article...]
admin posted on December 08, 2010 00:00
Designed for artists' paint waste disposal in small commercial and educational settings.
[Read the rest of this article...]
host posted on December 05, 2010 22:55
XTI introduces ACTIVE-SHIELD NANOCOATING, a revolutionary and environmentally-friendly transparent Photocatalyst Nanocoating for sterilizing consumer products and interior surfaces in buildings, medical facilities, automotives and airplanes
[Read the rest of this article...]
host posted on December 02, 2010 07:06
Leland Limited's Maximum Inflation® brand of marine products has developed reusable poly bags which prevent rust on steel tools and parts without using environmentally damaging oils
[Read the rest of this article...]
host posted on December 01, 2010 00:00
M. J. Kim, S. H. Lee, and J. G. Kim et al.
This study examined the influence of phosphorus addition on the corrosion resistance of carbon steel for a flue gas desulfurization (FGD) system using electrochemical methods, such as potentiodynamic polarization tests and electrochemical impedance spectroscopy (EIS) in 10 wt% sulfuric acid (H2SO4) ... [Corrosion 66, 125005 (2010)] published Wed Dec 01, 2010.
[Read the rest of this article...]
host posted on December 01, 2010 00:00
F. Gui, N. Sridhar, and J. A. Beavers et al.
Stress corrosion cracking (SCC) of carbon steel has been observed in fuel-grade ethanol (FGE, C2H5OH). Electrochemical behavior of carbon steel and therefore the role of localized corrosion in SCC has not been studied adequately because of the difficulty in performing electrochemical experiments in ... [Corrosion 66, 125001 (2010)] published Wed Dec 01, 2010.
[Read the rest of this article...]
host posted on December 01, 2010 00:00
S. B. Axelsen, R. Johnsen, and O. Ø. Knudsen et al.
This paper summarizes the results from laboratory investigations of the adhesion of polysiloxane topcoats. Low adhesion together with internal stress and lack of paint film flexibility and strength are expected to be the main reasons for the cracking and flaking of protective coatings. Internal str ... [Corrosion 66, 125003 (2010)] published Wed Dec 01, 2010.
[Read the rest of this article...]
host posted on December 01, 2010 00:00
Y. -S. Choi, D. Duan, and S. Nešić et al.
The objective of the present study was to evaluate the corrosion properties of carbon steel in MDEA/H2O/CO2/O2/HSS (methyldiethanolamine/water/carbon dioxide/oxygen/heat stable salts) mixtures related to the CO2 capture process in fossil fuel-fired power plants. Short-term and long-term corrosion t ... [Corrosion 66, 125004 (2010)] published Wed Dec 01, 2010.
[Read the rest of this article...]
host posted on December 01, 2010 00:00
Q. -Q. Liao, Z. -W. Yue, and Y. -J. Li et al.
Inhibition of brass corrosion by sodium diethyldithiocarbamate (DDTC) in 3% sodium chloride (NaCl) solution was investigated using the mass-loss method, electrochemical impedance spectroscopy (EIS), polarization curve method, and surface analysis method. Mass-loss results showed that the DDTC was a ... [Corrosion 66, 125002 (2010)] published Wed Dec 01, 2010.
[Read the rest of this article...]
host posted on December 01, 2010 00:00
D. Huenert, W. Schulz, and A. Kranzmann et al.
The most efficient construction materials for boiler water walls and superheaters in steam power plants are ferritic and martensitic steels. In practical operation, tubes are exposed simultaneously to combustion gas and air/steam on their opposite surfaces. The corrosion behavior of ferritic-marten ... [Corrosion 66, 126001 (2010)] published Wed Dec 01, 2010.
[Read the rest of this article...]